Click the Display Optimization button to proceed to that workflow section. If the Performance Analysis page indicates any red lights for display performance, you may wish to optimize the display’s picture controls before creating a 3D calibration LUT. In the Display Pre-Test section of the Color Cube workflow, you can measure the performance of a display before you calibrate it, on the Gamma & ColorChecker page and on the Advanced Linearity page.
#Aja lut box vs boxee generator#
Under Model, select SpectraCal – Cube Generator (3D LUT).On the Display dialog, under Manufacturer, select SpectraCal.On the Session Setup page, click the Find 3D LUT Device button.On the Source dialog, select your desired test pattern source.On the Session Setup page, click the Find Source button.
Under the Target Display Type drop-down select the display type that is being calibrated.On the Session Setup page, click the Find Meter button to connect your meter.Connect your color meter to the CalMAN computer.In the Initial Setup section of the Color Cube workflow, step through the following pages Session Setup – Meter Connect Proceed through the instructions on each step of the Color Cube workflow, using the following notes for AJA LUT-box specifics. In the CalMAN main menu, select Open Workflow Template / Color Cube (3D LUT). The Color Cube workflow in CalMAN is used to create 3D display calibration LUTs.
#Aja lut box vs boxee full#
When connected to an AJA LUT-box with firmware version 2.3 or higher, the LUT tab in the AJA Mini-Config utility provides the In/Out Color Range option for ‘Full’ or ‘SMPTE.’ This LUT range option must be set to Full to support a 3D LUT The Input tab and HDMI Output tab or SDI Output tab in the utility should be set to SMPTE. The AJA Mini-Config software is used to load the 3D LUT file into the AJA LUT-box. The AJA LUT-box, with firmware version 2.3 or 2.4, supports 3D LUTs only for SMPTE range operation. The AJA LUT-box does not need to be available during this display calibration and file creation process. cube file with the proper data format for later loading into the LUT-box (as detailed below). CalMAN Required VersionĬreating a 3D LUT Display Calibration File for the AJA LUT-boxĬalMAN creates a 3D LUT display calibration file for the AJA LUT-box without immediately loading the file into the LUT-box. This setup guide assists you in calibrating the AJA LUT-box with the CalMAN Color Cube workflow. CalMAN takes advantage of the AJA Video Systems LUT-box features to calibrate a video display with a 10-bit 17x17x17 3D cube lookup table (LUT) for SMPTE video level signals.
0 kommentar(er)
